Model name
SVP-10
65-20kHz
90 X 60
SVP-12
50-20kHz
90 X 60
SVP-12M
50 - 20kHz
90 X 60
SVP-15
45-20kHz
90 X 60
SVP-215
40-20kHz
90 X 60
SVP-15B
SVP-18B
SVP SERIES PROFESSIONAL SPEAKER USER MANUAL
FREQ RESP +/- 3 DB
COVERAGE (H X V)
45-250Hz
40-250Hz
SVP-10 • SVP-12 • SVP-12M • SVP-15 • SVP-215 •
SVP-15B • SVP-18B
POWER HANDLING (Watts)
Continuous
Music
peak
100
200
400
150
300
600
150
300
600
200
400
800
250
500
1000
250
500
1000
300
600
1200
SENSITIVITY 1W@1M
PEAK SPL
96dB
121.5dB
8Ω
97dB
124.5dB
8Ω
97dB
124.5dB
8Ω
98dB
126dB
8Ω
101dB
129.5dB
4Ω
98dB
126.5dB
8Ω
99dB
129.5dB
8Ω
ƽ WARNING & SAFETY INSTRUCTIONS
SYSTEM IMPEDANCE
L F DRIVER SIZE
Driver size
1. READ INSTRUCTIONS carefully before operating this product.
RETAIN these instructions.
5. CABLES - Never use shielded or microphone cable for any speak-
er connection as this will not be heavy enough to handle the amplifier
load and could cause damage to the complete system.
10”
12”
12”
15”
15”
15”
18”
2.
Coil Size (mm/ins)
HF SECTION
39/1.5”
51/2”
51/2”
51/2”
38/1.5”
65/2.5”
75/3”
3. COMPLY WITH WARNINGS - All warnings and instructions for this
product should be adhered to.
6. ƽ ꢀ RIGGING • SUSPENDING • MOUNTING
Coil Size (mm/ins)
Exit Size (mm/ins)
HF Protection
25 / 1”
30/1.2”
Bulb
25 / 1”
30/1.2”
Bulb
25 / 1”
30/1.2”
Bulb
25 / 1”
30/1.2”
Bulb
25 / 1”
30/1.2”
Bulb
-
-
-
-
-
-
-
-
The rigging, suspension or mounting of this speaker system can
expose members of the public to serious health risks and even death.
UNDER NO CIRCUMSTANCES ATTEMPT TO RIG, SUSPEND OR
OTHERWISE MOUNT THIS SYSTEM UNLESS YOU ARE FULLY
QUALIFIED AND CERTIFIED TO DO SO BY RELEVANT LOCAL,
STATE AND NATIONAL AUTHORITIES. ALL RELEVANT SAFETY
REGULATIONS MUST BE FOLLOWED. IF YOU ARE NOT PROP-
ERLY QUALIFIED OR DO NOT KNOW OF PERTINENT REGULA-
TIONS, CONSULT QUALIFIED PERSONNEL FOR ADVICE AND
ASSISTANCE.
4. USE WITH AMPLIFIERS - In order to avoid damage, it is advis-
able to establish and follow a pattern for turning on and off any sound
system. With all system parts connected, turn on source equipment,
tape decks, instruments, mixers, signal processors etc., BEFORE
turning on your power amplifier. Many products output turn on and
turn off transients that can damage speakers. By turning on your
power amplifier LAST and making sure the amplifier’s input controls
are at minimum any transients “upstream” of the amplifier are not
amplified and passed to the speaker. Wait until all system parts have
stabilised, then bring up amplifier controls to operating level. This
should take no more than a few seconds. Similarly when shutting
systems down, always turn down amplifier input controls and then
turn off your amplifier BEFORE shutting down other components.
Professional amplifiers often feature delayed turn on/off circuits to
perform these functions for you automatically.
HF HORN
Elliptical
Elliptical
Elliptical
Elliptical
Elliptical
CROSSOVER SECTION:
Crossover frequency
High Pass Out
3.2k
No
3.2k
No
3.2k
No
3.2k
No
3.2k
No
150Hz/6dB
150Hz/6dB
150Hz/6dB
150Hz/6dB
ENCLOSURE TYPE
Shape
Trapezoid
Carpet/Black
Yes
Trapezoid
Carpet/Black
Yes
Floor monitor
Carpet/Black
No
Trapezoid
Carpet/Black
Yes
Trapezoid
Carpet/Black
No
Rectangular
Carpet/Black
Yes
Rectangular
Carpet/Black
Yes
Finish Colour
Stand Adaptor
Protect Corner
Handle
Black metal
Black metal
Black metal
Black metal
Black metal
Black metal
Black metal
7. Ꮧ CAUTION: These professional loudspeaker systems are capa-
ble of generating very high sound pressure levels. Use care with
placement and operation to avoid exposure to excessive levels
that can cause permanent hearing damage.
2
2
2
2
2
2
2
1
1
1
1
1
1
1
INPUT CONNECTOR
2 x
⁄
4”phone
No
2 x
⁄
4” phone
No
2 x
⁄
4” phone
No
2 x
⁄
4” phone
No
2 x
⁄
4” phone
No
2 x
⁄
4” phone
2 x
⁄
4” phone
1
1
HIGH PASS OUT
⁄
4” phone
⁄4” phone
DIMENSIONS (H x W x D)
494 x 317 x 288 554 x 428 x 355 415 x 248 x 554 638 x 463 x 390 1014 x 463 x 390 587 x 548 x 429 748 x 548 x 450
10.28kg 15.58kg 14.9kg 19.26kg 31.0kg 31.52kg 38.56kg
8. SERVICING - The user should not attempt to service this prod-
WEIGHT
uct.
Wharfedale Pro SVP Series of Professional Sound Reinforcement Loudspeakers
SVP-15B AND SVP- 18B SUB-WOOFER:
● Reliable, Durable construction
● Trapezoid shape for arraying cabinets
● Integral tripod stand adaptor
Application
● Proprietary designed, high efficiency, high power
For extended bass response in a multi way (2 or more) equalized
system designed for high quality reproduction of voice, music and
musical instruments, for mobile or fixed installations.
Wharfedale Professional drive units.
● Low resonance enclosure design
● Protective grills
● Full range and complimentary Sub Bass systems
Description
● Integral High Frequency Driver Overload protection
● Exceptional sound quality, with broad bandwidth
These cabinets are all covered in tough impact resist carpet. They
are designed for portability and are fitted with heavy duty handles
and a ‘kick -proof’ steel protective grille. The SVP-18B and the SVP-
15B have two 1/4” phone type jack sockets and are paralleled at the
rear of each cabinet. (See diagram ).
“PRO-TECH”™
and dynamic range
● Sophisticated crossover design enables smooth
power and frequency response control through
crossover region
● High Power Handling
● Metal corner protectors
A very special feature of these products is that they have built-in
crossovers with high-pass outputs. This means that you may use
one channel of your power amplifier to power both a subwoofer and
a full-range speaker, while maintaining a reason-able load on your
amplifier. The amplifier only sees the subwoofer/crossover load
which is 8 ohms for SVP series subwoofers. Without the built-in
crossover, the combined impedance of full-range and subwoofer
speakers in parallel would be much lower. Also, the high-pass
crossover output removes the very low bass frequencies from the
signal going to the full-range speaker. This prevents distortion (and
possible damage) from excessive low-frequency energy getting into
the full-range speaker.
Unpacking
All Wharfedale Pro products are fully
checked before leaving the factory. After
unpacking please inspect cabinets for any
Wharfedale Pro Limited Warranty*
Wharfedale Pro SVP Series loudspeaker systems are warranted to be
clear of manufacturing or materials defects for a period of one year from
the original date of purchase. In the event of malfunction, contact your
authorised Wharfedale Professional dealer or distributor for information.
physical damage. Please retain the shipping
carton if possible and internal packing material in case the unit
needs to be returned. Please check as soon as possible the unit is
functioning. In the event of any damage please contact your dealer
immediately so that a written claim for damages can be made.
*Be aware that warranty details may differ from country to country. Contact your dealer or
distributor for information.
These terms do not infringe your statutory rights.
SVP 10, SVP-12,SVP-15,SVP215
Operating:
The Wharfedale Pro SVP-10, SVP-12, SVP15 and SVP-215 fea-
Note: Each speaker connected in parallel increases the load on
the amplifier and can add up to a total load that may exceed the
amplifier’s capabilities, leading to possible damage.Two 8Ω loud-
ture two 1/4”phone jack socket connectors and are paralleled. speakers in parallel make a 4Ω total load. Four 8Ω parallel con-
This means that these cabinets can be linked together with
other cabinets of the same impedance and design or with a
sub-bass unit.
CAUTION: If you are unsure of any of thes procedures, check
with your dealer or an experienced sound engineer.
(1) Ensure you do not overload the amplifier you are using by
linking too many units together and lowering the resistance
(impedance) below the safe operating level of the amplifier.
nected loudspeakers make a total load of 2Ω, which is too low for
many amplifiers.
(2) Make sure that the speaker cable used is securely
attached to the amplifier and the cabinet.
(3) Check all cables from the source unit (mixer or other
source) to the amplifier. Check all power cables to all the
electronic systems powering the loudspeakers and ensure
that they meet with required safety standards.
911.400
Wharfedale International Limited, IAG House, Sovereign Court, Ermine Business Park, Huntingdon, Cambs, PE29 6XU England
IAG Professional reserve the right to alter or improve specifications without notice.All rights reserved © 2004 Wharfedale Pro. A member of the International Audio Group
|